Unify OpenStage 60 T User Manual

Making calls in the team/executive/secretary configuration 107
Answering calls with the trunk keys
Prerequisite: You can see an incoming call on a trunk.
if nec. T Press the trunk key that is flashing quickly. 
(only if Prime Line  page 105 is not active).
^ Lift the handset.
or Speakerphone mode.
Dialing with trunk keys
if nec. S Select a line (only if Prime Line  page 105 is not active).
j Enter the station number.
^ Lift the handset.
or Speakerphone mode.
Placing a call on hold on a trunk key and retrieving
the held call
Prerequisite: You are conducting a call via one of your group’s trunks. The
"Hold" key has been programmed on your telephone
 page 71.
Hold
S Press the "Hold" key.
if nec.
\ or s Replace the handset or press the key shown.
Depending on the configuration (contact your service personnel), this may be
necessary so other team members can also pick up the call on hold.
Retrieving the call
T Press the trunk key flashing slowly.
Making calls on multiple lines alternately
Prerequisite: You are conducting a call via one of your group’s trunks. Another
trunk key is flashing.
T Press the flashing trunk key. The first call party is on hold on the other trunk.
T Press the trunk key flashing slowly. The second call party is on hold.
You can switch between lines as often as you wish. Press the trunk key flashing
slowly each time.

Unify OpenStage 60 T Specifications

General

Brand	Unify
Model	OpenStage 60 T
Category	IP Phone
Language	English