TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
24
5. Maintenance
The spare handset must be an unlicensed WL3 to move the licenses to the spare
handset. To check that the handset is unlicensed, press *#34# in idle mode and select
“License“. Only WL3 must be displayed here.
1 Make sure that the broken handset is saved in the Device Manager (indicated by
a
in the Saved column. If not, in the Numbers tab, right-click the broken
handset and select “Save“.
2 Switch the broken handset off. The handset appears as offline in the Device
Manager.
3 Take an unlicensed spare handset (WL3) prepared with the network settings
(including the IP-address to the WSG).
4 Enter the number and leave the password blank. Press “Login”. The handset is
now online in the Device Manager.
5 Make sure that the spare handset is saved in the Device Manager (indicated by
a
in the Saved column. If not, in the Numbers tab, right-click the spare
handset and select “Save“.
6 Switch the spare handset off. The handset appears as offline in the Device
Manager.
7 Switch the broken handset on. The handset appears as online in the Device
Manager.
8 In the Device Manager, select the “Licenses“ tab.
9 Right-click the broken handset and select “Move license...“.
10 In the Move license window, select the WL3 that should receive the license.
Press “OK“.
11 The broken handset restarts and has now become a WL3. Switch the broken
handset off. The handset appears as offline in the Device Manager.
12 Switch the spare handset on. The handset appears as online in the Device
Manager.
13 In the Device Manager, select the “Licenses“ tab. Right-click the spare handset
and select “Refresh“.
The spare handset is automatically updated from the WSG and restarted. The last
stored settings and licenses for the broken handset in the WSG are transferred to the
spare handset.
5.2.3 Replacement of the Handset with WinPDM and WSG
If the spare handset to be used must be factory reset or no network template has been
applied, a WinPDM is needed to apply the network template to the spare handset.
When the network template is added, the handset can log on to the Device Manager.
There are two different replacement procedures as follows:
• If the broken handset and the spare handset have the same device type and
functionality license, see
Replace without Move Licenses using WinPDM and WSG.
• If the broken handset and the spare handset do not have the same device type and/
or functionality license. The license must be moved to the spare handset, see
Replace and Move License using WinPDM and WSG on page 25.
Replace without Move Licenses using WinPDM and WSG
Both the broken handset and the spare handset must be of the same device type and
have same functionality license.
To Next Page
Loading...
Need help?
General