EasyManuals Logo
Home>Unify>Handsets>OpenStage WL3

Unify OpenStage WL3 Administration Manual

Unify OpenStage WL3
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
38
6. Handset Configuration
NOTE: If configured, it is possible to dial any of up to five predefined emergency
numbers when the handset is locked, see
6.10.6 Emergency Call Numbers on
page 58. It is not recommended to use Phone Lock when using the Shared
Phone feature, see 6.5.12 Shared Phone on page 41
1 Select Device > Settings.
2 In the Phone lock drop-down list, select one of the following:
On - the handset will be locked after a few seconds when it is not used and a
password is required to open it again
On in charger - the handset is be locked when placed in charger.
Off - the phone lock is not activated.
6.5.3 Automatic lock time
When either the key lock or the phone lock is set to On, the lock is activated after the
specified time. It is possible to change the default time of 20 seconds.
1 Select Device > Settings.
2 In the Automatic lock time drop-down list, select desired time:
5, 10, 20, 30 seconds, 1, or 3 minutes.
6.5.4 Automatic key unlock
1 Select Device > Settings.
2 In the Automatic key unlock drop-down list, select one of the following:
On - the handset keypad is locked up automatically at incoming calls and
messages.
Off - the handset is not locked up automatically to avoid unintentional key
press
6.5.5 Audio adjustment
Select the volumes for the different audio signals in the handset.
1 Select Audio > Volume.
2 Select the appropriate volume type from the drop-down lists:
Handsfree volume
Headset volume
Speaker volume
3 In the Persistent volume drop-down list, select “Enable” to automatically store
volume changes in the handset for future calls.
The parameter affects the “Normal”, “Headset“, “Loudspeaking“ mode.
For selection of headset, see Headset type on page 38.
NOTE: Changing this parameter can result in lower sound quality and high sound level.
Evaluate carefully before applying.
6.5.6 Headset Configuration
Headset type
Select the headset model that is used.

Table of Contents

Other manuals for Unify OpenStage WL3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Unify OpenStage WL3 and is the answer not in the manual?

Unify OpenStage WL3 Specifications

General IconGeneral
BrandUnify
ModelOpenStage WL3
CategoryHandsets
LanguageEnglish