TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
89
Appendix C: Easy Deployment
Appendix C: Easy Deployment
With the Easy Deployment process, a handset is installed without the need for the
WinPDM, by using a (staging) WLAN, with a predefined SSID and security profile.
NOTE: Easy Deployment can only be used in a 2.4 GHz staging WLAN. This is the
default frequency band of the handset, when switched on. Thereafter the
production WLAN is used with any configured channel and band.
C.1 Prerequisites
• The WLAN network needs at least one AP on the 802.11b/g radio, that allows
access to the WSG, and uses the following default configuration, which cannot be
changed:
• In the handset, all other network parameters must be at their default settings, which
means for instance:
• If it is used in the WSG server, the password to log in is needed.
• The WSG server port must be open and not blocked.
• No SSID for any of the networks A-D is configured in the handset.
• The DHCP offer for the AWS-INIT network must include an IP address of an NTP
server, to provide the handset with the correct system time (needed for certificate
validations).
NOTE: The intended number to be used by a handset, is entered from the handset’s
keypad, after a successful first access to the Messaging server(WSG).
The Easy Deployment process, consists of three phases:
• WLAN discovery
• WSG server discovery
• Parameter download
SSID: AWS-INIT
Security key: WPA-PSK / WPA2-PSK
WPA-PSK passphrase: AWS-INIT
DHCP mode: On
802.11 protocol: 802.11b/g/n
802.11b/g/n channels: 1,6,11
World mode regulatory domain: World mode (802.11d)
To Next Page
Loading...
Need help?
General