TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
87
Appendix B: Programming Custom
Figure 11. Example of a melody/text string.
.
B.1 Customize the default handset beeps
If it is desired to create a custom sound out of any of the default handset beeps (Beep
1 - 7 and Enhanced beeps 1 - 7), the default definition of each beep can be used as a
starting point for the further programming of the sound. The default definitions are as
follows:
Vibration N/A Vibeon
Vibeoff
Repeat N/A @0 (repeat forever)
@<number of repetitions>, for example: "@2"
repeats the melody string 2 times.
1 Octave-prefix
2 Vibration is turned on. The handset vibrates continuously.
3 Basic note with 1/8 duration
4 Iss note with 1/8 duration
5 Vibration is turned off
6 Short pause
7 The melody within brackets is repeated 3 times before the handset
plays the rest of the melody.
8 Long pause
Beeps: Definition (default):
Beep 1: *5b4r4
Beep 2: (*5b4r4@2)
Beep 3: (*5b4r4@3)
Beep 4: (*5b4r4@4)
Beep 5: (*5b4r4@5)
Beep 6: (*5b4r4@10)
Beep 7: (*6e4*6a4*6e4*6a4r4@10)
Enhanced beeps: Definition (default):
Enhanced beep 1: *6e2r2r1
Element Sub element Values
(
To Next Page
Loading...
Need help?
General