TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
60
6. Handset Configuration
6.10.13 Call waiting behavior
The default behavior is to indicate “call waiting” to the user. It is possible to change this
behavior so that the next incoming call is rejected, and a busy indication is sent back to
the SIP proxy.
1 Select Device > Call.
2 In the Call waiting behavior drop-down list, select one of the following:
• Call waiting indication - The call is usually indicated by a short two-beep tone
and an “Incoming call” dialog window in the handset display.
• Reject call - The call is automatically rejected (No beep tone or dialog window
occurs).
6.10.14 Calling Line Identification Restriction (CLIR)
The handset can be configured to hide the calling number and name to the called party.
NOTE: Even if CLIR is enabled, there is an override function available to authorities,
such as the police, that allows the caller identity to be seen, even if CLIR is
enabled.
1 Select Device > Call.
2 In the CLIR (Calling Line Identification Restriction) drop-down list, select “On”.
6.11 Regional Settings
This section includes settings suitable for a specific region or country.
6.11.1 Set Time & Date
1 Select Device > General.
2 In the Time zone drop-down list, select the applicable time zone.
To Next Page
Loading...
Need help?
General