TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
62
6. Handset Configuration
2 In the Language drop-down list, select the language to be used.
3 If the downloaded language is selected, it might be needed to select matching
characters as text input language, and the sort order in the phonebook
In the Input Language drop-down list, select the text input language to be used.
NOTE: This parameter is only applicable for the downloaded language and cannot be
changed by the user. See
6.5.13 Uploadable Language on page 42 for more
information.
6.11.3 Dialing Tone Pattern
Defines the tone pattern to use when dialing.
1 Select Audio > General.
2 In the Dialing tone pattern drop-down list, select the applicable region.
6.12 Display
6.12.1 User Display Text
Defines the text to be shown in the display in idle mode instead of the endpoint ID. If
nothing is entered in this text field, the endpoint ID is displayed.
1 Select Device > Settings.
2 In the User display text field, enter the text to be displayed.
6.12.2 Rotate Display Text
The handset can be configured to show the contents of the display (except the soft key
bar) upside-down at incoming calls or messages.
1 Select Device > Settings > Display.
2 In the Rotate display text list, choose Normal or Inverted.
6.12.3 Font style
The display font style can be changed to bold for increased readability.
1 Select Device > Settings.
2 In the Font style list, choose Normal or Bold.
6.12.4 Backlight Timeout
Numbers of seconds before the backlight is turned off.
1 Select Device > General.
2 In the Backlight timeout field, enter number of seconds before the backlight is
turned off when handset is in idle mode.
6.12.5 Brightness
1 Select Device > Settings.
To Next Page
Loading...
Need help?
General