– When pressing off tire on a tire mounting device with press-off
blade, always make sure that tire valve/ Tire Pressure Moni‐
toring Sensor -arrow- is located opposite the press-off blade
-1-.
Press-off blade must be applied at maximum 2 cm removed from
rim flange.
– Remove the balance weight and any dirt from the disc wheel.
– Press off both tire beads all the way around while thoroughly
applying tire mounting paste between the tire and rim flange
-arrow-.
4.5 Tires, Dismounting
Caution
♦ Pay attention to the safety precautions and conditions.
Refer to
⇒ “4.1 Safety Precautions and Conditions for Removing
and Installing Tires, Wheels with TPMS”, page 240 .
♦ Mounting head must not be located in area -a- of tire valve/
tire pressure monitoring sensor, otherwise the mounting
head will damage the Tire Pressure Monitoring Sensor .
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
4. Tires, Wheels with TPMS, Removing and Installing 243
ProCarManuals.com
To Next Page
Loading...
Need help?
General
