Component Tightening Specification
Union nut, pressure/return line to the steering gear 32 Nm
Exhaust system bracket to subframe. Refer to ⇒ Engine Mechanical, Fuel Injection and Ignition; Rep. Gr.
26 .
Tightening Specification, Pendulum Support to the Transmission
Bolt Tightening Specification
M10 x 35
♦ Use a new bolt
50 Nm + 90° turn
M10 x 75
♦ Use a new bolt
50 Nm + 90° turn
4.7 Subframe with Electromechanical
Steering Gear, Removing and Installing
Special tools and workshop equipment required
♦ Puller - Ball Joint - T10187-
♦ Torque Wrench 1332 40-200Nm - VAG1332-
Perform the Following
Removing
– Disconnect the cable -1- from the E-box.
– Disconnect the connector -1-.
– Remove the cap nut -arrow- and disconnect the ground wire.
– Remove the wiring harness from the bracket on the longitudi‐
nal member so that it can be removed together with the
steering gear.
– Turn the steering wheel in the straight position and remove the
ignition key so that the steering wheel lock engages.
Vehicles with “Keyless Access” Keyless Locking and Starting
System
– Switch the ignition off and open the driver door so the steering
wheel lock engages.
Continuation for All Vehicles
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
26 Rep. Gr.40 - Front Suspension
ProCarManuals.com
To Next Page
Loading...
Need help?
General
