7.2 Tire Pressure Monitoring Sensor , Re‐
moving and Installing
Removing
– Remove the union nut -1-.
– Remove the Tire Pressure Monitoring Sensor -2- from rim well.
Installing
Caution
Clean the valve opening before installing the Tire Pressure
Monitoring Sensor .
– Insert the Tire Pressure Monitoring Sensor -2- with the new
seal and sealing washer. Press the Tire Pressure Monitoring
Sensor on the spots marked with the -arrows- into the disc
wheel (rim).
– Press the Tire Pressure Monitoring Sensor -2- on the spots
marked with the -arrows- into the disc wheel (rim).
Install the union nut -1- on the tire pressure monitoring sensor.
– Install the Tire Pressure Monitoring Sensor -1- on the marked
positions -arrows- in the rim and tighten the union nut to 8 Nm.
Caution
♦ Tighten the union nut only to the tightening specification.
♦ Sealing washer -2- becomes slightly deformed when do‐
ing this.
♦ The sealing washer can be installed one time only. At ev‐
ery installation, replace the sealing washer and rubber
seal.
♦ Do not tighten the union nut again. This will damage the
seal and it will leak.
Tightening Specification
Component Tightening Specification
Union nut to the Tire Pressure Monitoring Sensor 8 Nm
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
7. Tire Pressure Monitoring System 255
ProCarManuals.com
To Next Page
Loading...
Need help?
General
