6 Electromechanical Steering Gear
⇒ “6.1 Overview - Electromechanical Steering Gear”, page 319
⇒ “6.2 Steering Gear, Removing and Installing”, page 320
6.1 Overview - Electromechanical Steering Gear
Caution
If the universal joint is separated from the Electromechanical
steering gear, the following work cannot be performed:
These points must be observed since performing these actions
could cause irreparable damage.
1 - Wire
2 - Universal Joint
3 - Bolt
❑ 30 Nm
❑ Always replace if re‐
moved
❑ M8 x 35
4 - TORX
®
Bolt
❑ 6 Nm
❑ Self-tapping
5 - Heat Shield
6 - Power Steering Gear
❑ With Power Steering
Control Module - J500-
❑ With Electromechanical
Power Steering Motor -
V187-
❑ With Steering Angle
Sensor - G85-
❑ With Steering Torque
Sensor - G269-
❑ Can be checked in Gui‐
ded Fault Finding using
the Vehicle Diagnostic
Tester .
❑ Removing and instal‐
ling. Refer to
⇒ “6.2 Steering Gear,
Removing and Instal‐
ling”, page 320 .
Note
Correct any faults stored in the DTC
memory before replacing the steer‐
ing gear using the Vehicle Diagnos‐
tic Tester .
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
ProCarManuals.com