– Connect the connector -1-.
Vehicles with “Keyless Access” Keyless Locking and Starting
System
– Connect the connector -1-.
– Clip the wire into the retainer on the Electronic Steering Col‐
umn Lock Control Module - J764- -arrow-.
Continuation for All Vehicles
– Install the steering column switch. Refer to ⇒ Electrical Equip‐
ment; Rep. Gr. 94 ; Steering Column Switch Module; Over‐
view - Steering Column Switch Module .
– Install the steering column trim. Refer to ⇒ Body Interior; Rep.
Gr. 68 ; Storage Compartments and Covers; Steering Column
Trim Panel, Removing and Installing .
– Install the steering wheel. Refer to
⇒ “3.2 Airbag Steering Wheel, Removing and Installing”, page
295 .
– Install the driver side airbag unit. Refer to ⇒ Body Interior; Rep.
Gr. 69 ; Driver Side Airbag; Airbag Unit with Driver Airbag
Igniter - N95- , Removing and Installing .
– Perform a basic setting on the Steering Angle Sensor - G85-
using the Vehicle Diagnostic Tester .
Tightening Specifications
Component Tightening Specification
Universal joint to steering gear
♦ Use a new bolt
30 Nm
Steering column to mounting bracket 20 Nm
4.3 Steering Column, Handling and Trans‐
porting
WARNING
♦ The correct handling of the steering column must always
be observed.
♦ Incorrect handling of steering column may cause damage
to steering column and therefore lead to a safety risk.
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
4. Steering Column 305
ProCarManuals.com