– Tighten the bolts in the shown sequence to the tightening
specification.
– Install the cable guide -1- under the steering column.
Tabs -arrow- must engage into guide on both sides.
– Attach the ground cable to the steering column.
– Install the universal joint -1- on the steering pinion in direction
of -arrow-.
– Install and tighten the new bolt -arrow-.
– Install the footwell trim -2- and tighten the nuts -1-.
Vehicles with Ignition Switch
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
304 Rep. Gr.48 - Steering
ProCarManuals.com
To Next Page
Loading...
Need help?
General
