EasyManuals Logo

Volkswagen Jetta 2011 User Manual

Volkswagen Jetta 2011
390 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #291 background imageLoading...
Page #291 background image
Note
To mount wheel on wheel balancer, use for example Wheel
Centering System Adapter - VAS5271- .
This way a 100% centering of the wheel and gentle mounting
is possible!
It is not possible to center it 100% on balancing machine with
conical tensioners.
With a deviation of 0.1 mm outside the center, there is an im‐
balance of 10 grams on the wheel/tire.
Wheel/Tire Balancing Procedure
Let the wheel/tire turn on the balancing machine.
Check the run of the characteristic lines on the sidewall of the
tire in the area of the rim flange.
Check the tire wear pattern while the wheel/tire is turning.
Note
In the event of one-sided wear, flat spots from braking or severe
wear spots, smooth running cannot be achieved by balancing. In
this case, the tire must be replaced.
Check the run-out on the wheel/tire. If the wheel with tire runs
untrue although there are no flat spots, a radial or lateral run-
out may be the cause.
Check wheel with tire for radial- and lateral run-out. Refer to
⇒ “12.8 Wheels and Tires, Checking Radial and Lateral Run-
Out with Tire Dial Gauge VAG1435 ”, page 286 .
If the radial and lateral run-out are within the specified toler‐
ance, balance the wheel and tire.
Note
Do not use more than 60 grams of weight per wheel.
If more weight is necessary, a smoother running can achieved
by matched mounting of the tire. Matched mounting of tire.
Refer to ⇒ “12.10 Matching”, page 287 .
The display in the balancing machine should show 0 grams.
Hunter RFT33VAG Road Force Touch™ Wheel Balancer -
VAS6230B4- can be inserted as an alternative to matching.
Refer to
⇒ “12.5 Hunter RFT33VAG Road Force Touch™ Wheel Bal‐
ancer VAS6230B4 ”, page 284 .
Install the wheel on the vehicle.
First, tighten the lowest wheel bolt by hand to approximately
30 Nm.
Tighten the remaining wheel bolts diagonally to approximately
30 Nm. This process centers the wheel on the wheel hub.
Lower vehicle onto its wheels.
Now use a torque wrench to tighten the wheel bolts diagonally
to the specified tightening specification.
Jetta 2011 ➤ , Jetta 2013 ➤
Suspension, Wheels, Steering - Edition 08.2015
12. Wheel/Tire Vibration, Causes and Solution 283
ProCarManuals.com

Table of Contents

Other manuals for Volkswagen Jetta 2011

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Volkswagen Jetta 2011 and is the answer not in the manual?

Volkswagen Jetta 2011 Specifications

General IconGeneral
BrandVolkswagen
ModelJetta 2011
CategoryAutomobile
LanguageEnglish

Related product manuals