Xerox Phaser 6125 Service Manual

3-80 Phaser 6125/6130 Color Laser Printer Service Manual
Error Messages and Codes
K Mode Sol Error
K Mode Solenoid (Color Mode Switching Solenoid) error is detected.
Applicable Chain Link
■ 042-372: K Mode Solenoid Error
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Feed Drive Assembly (Drive Assy
PH), PL7.1.4
■ MCU Board, PL8.2.13
■ “Map 4 - Toner Dispenser Motors, HVPS,
MCU” on page 10-11
■ “Drive” on page 10-20
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Reseat the Imaging Unit.
Does the error still occur when the
power is turned OFF and ON?
Go to step 2. Complete
2 Perform the K Mode Solenoid test
(page 4-29): Service Mode > Motor
Test > K Mode Solenoid.
During this check, close the Front
Cover.
Does the solenoid click when the K
Mode Solenoid check is performed?
Go to step 7. Go to step 3.
3 Check the connection between the
MCU Board and K Mode Solenoid.
Is P/J24 connected securely?
Go to step 5. Reconnect the
connector P/J24
correctly, then
go to step 4.
4 Does the error still occur when the
power is turned OFF and ON?
Go to step 5. Complete
5 Check the power to the K Mode
Solenoid
Disconnect J24 from the MCU Board.
Is the voltage across P24-1pin <=>
ground on the MCU Board, about +24
VDC when the Interlock Switch (HARN
ASSY INTERLOCK) is pushed?
Go to step 6. Replace the
MCU Board
(page 8-59).

Xerox Phaser 6125 Specifications

General

Color	Yes
Print technology	Laser
Maximum resolution	2400 x 600 DPI
Time to first page (black, normal)	17 s
Time to first page (color, normal)	14 s
Print speed (black, normal quality, A4/US Letter)	16 ppm
Print speed (color, normal quality, A4/US Letter)	12 ppm
Internal memory	64 MB
Sound power level (standby)	25.7 dB
Sound pressure level (printing)	51.6 dB
Total input capacity	250 sheets
Total output capacity	150 sheets
Media weight (tray 1)	64 - 220 gsm
Paper tray media types	Envelopes, Glossy paper, Labels, Plain paper
Non-ISO print media sizes	Letter
Multi-Purpose Tray media weight	64 - 164 g/m²
Power requirements	240 V, 50/60 Hz
Networking features	10/100BaseTX
Power consumption (active)	280 W
Maximum duty cycle	40000 pages per month
Sustainability certificates	ENERGY STAR
Power consumption (standby)	50 W
Power consumption (PowerSave)	5 W
Storage temperature (T-T)	0 - 35 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	15 - 85 %
Certification	CE, UL 60950-1/CSA 60950-1-03, EMC 89/336/EEC, FCC 15 B, 73/23/EEC, 2002/95/EC

Weight and Dimensions

Dimensions (WxDxH)	400 x 394 x 389 mm