Xerox Phaser 6125 Service Manual

4-2 Phaser 6125/6130 Color Laser Printer Service Manual
General Troubleshooting
Introduction
This chapter covers the System Startup, Power On Self Test (POST), Service
Diagnostics, and troubleshooting problems that are not associated with a
Chain Link code or Control Panel error message.
For troubleshooting problems associated with a Chain Link code or Control
Panel error message, refer to “Error Messages and Codes” on page 3-1.
Print-quality problems are covered in “Print-Quality Troubleshooting” on
page 5-1.
System Startup
Listed here is a typical startup routine from a cold start. The printer requires
approximately 20 seconds to complete this sequence.
1. When the power switch is turned On, the “Health” LED on the Image
Processor Board turns On immediately.
2. The Boot Loader checks for RAM present and functional. If an error is
detected, RAM ERROR is displayed and the Health LEDs alternately
blink at 1/2 second intervals.
3. The Boot Loader then loads and runs POST diagnostics.
4. POST turns Off the Health LED.
5. POST checks the Control Panel.
6. The Control Panel LED cycles: Green and Red simultaneously, and
Green.
7. The Control Panel LED turns Green and Red and Diagnosing...
message is displayed.
8. The Control Panel message changes to Ready Calibrating and then
Xerox (TM) Toner Cartridge.
9. The Control Panel LED turns Green and the Ready message is
displayed.

Xerox Phaser 6125 Specifications

General

Color	Yes
Print technology	Laser
Maximum resolution	2400 x 600 DPI
Time to first page (black, normal)	17 s
Time to first page (color, normal)	14 s
Print speed (black, normal quality, A4/US Letter)	16 ppm
Print speed (color, normal quality, A4/US Letter)	12 ppm
Internal memory	64 MB
Sound power level (standby)	25.7 dB
Sound pressure level (printing)	51.6 dB
Total input capacity	250 sheets
Total output capacity	150 sheets
Media weight (tray 1)	64 - 220 gsm
Paper tray media types	Envelopes, Glossy paper, Labels, Plain paper
Non-ISO print media sizes	Letter
Multi-Purpose Tray media weight	64 - 164 g/m²
Power requirements	240 V, 50/60 Hz
Networking features	10/100BaseTX
Power consumption (active)	280 W
Maximum duty cycle	40000 pages per month
Sustainability certificates	ENERGY STAR
Power consumption (standby)	50 W
Power consumption (PowerSave)	5 W
Storage temperature (T-T)	0 - 35 °C
Operating temperature (T-T)	10 - 32 °C
Operating relative humidity (H-H)	15 - 85 %
Certification	CE, UL 60950-1/CSA 60950-1-03, EMC 89/336/EEC, FCC 15 B, 73/23/EEC, 2002/95/EC

Weight and Dimensions

Dimensions (WxDxH)	400 x 394 x 389 mm