Xerox Phaser 6500 Service Manual

Phaser 6500/WorkCentre 6505 Service Manual Xerox Internal Use Only 6-11
Adjustments and Calibrations
Scanner Parameter Setting
Perform this procedure following replacement of the Scanner Assembly, or when
instructed to do so in a troubleshooting or repair procedure.
1. Lift the Scanner cover and locate the parameter label at the rear of the platen.
Note the location and format of the parameter values on the label. The FB
and ADF lines have parameter values for R, G, B, and BW. In this illustration,
the parameter values are enclosed in red boxes.
2. Simultaneously press the Up and Down keys while powering on the MFP to
enter Service Mode.
3. Select Fax/Scanner Diag and press OK.
4. Scroll to Scanner Maintenance and press OK.
5. Scroll to Shading Parameter and press OK.
6. Select Coeff FB RED and press OK.
7. Enter the “R” parameter from the FB line and press OK to set.
8. Confirm that an asterisk (*) appears, then press Back.
9. Press the Down key to select the next parameter and enter the appropriate
value from the label.
Note
Use the BW parameter value for the GRAY entries.
10. After all the Coeff FB and Coeff ADF values are entered, use the Back button
to return to Scanner Maintenance.
11. Scroll down to Complete and press OK at each prompt until you exit Service
Mode.
s6500-102s6505-500
Made in china
CN-062K21290-023-F008A000003M
FB-R8b61-G907d-B8e43-BW8f00
ADF-R8dba-G8eee-B8bf4-BW8f73

Xerox Phaser 6500 Specifications

General

Brand	Xerox
Model	Phaser 6500
Category	Printer
Language	English