June 2014
4-35
Xerox® WorkCentre® 3215/3225 Multifunction Printer Service Manual
REP 1.25
Repairs
2. Remove the Document Feed Roll Assembly (Figure 2).
a. Remove the E-Rings (3).
b. Slide the drive shaft out of the Feed Roll Assembly.
Figure 2 Feed Roll E-rings
Replacement
Install the components in the reverse of removal.
NOTE: Install the E-rings in the following order:
1. The E-ring by the gear.
2. The E-ring (center) by the Spring.
3. The E-ring at the end of the shaft.
REP 1.25 ADF Drive Motor
Parts List on PL 1.2
Removal
1. Switch Off the Printer and unplug the Power Cord.
2. Remove the ADF (REP 1.22).
3. Remove the ADF Rear Cover (Figure 1):
a. On the underside of the ADF, remove the Rear Cover screws (3).
b. Lift the Top of the cover away from the ADF, then pull the bottom away to release the
latches.
Figure 1 Rear Cover Screws (Bottom View)
E-rings
Screws
To Next Page
Loading...
Need help?
General
