Channel Job
Reference Manual
76
CH MOVE MODE window
1 SOURCE CH field
Displays the move-source channel. While this window is displayed, press a [SEL] key on
the top panel to select an input channel. The selected channel will be highlighted in this
field. If you want to re-select the move-source channel, press this field.
2 DESTINATION CH field
Displays the move-destination channel. When you specify the move-source, you can
then select the move-destination input channel by pressing its [SEL] key on the panel.
When the move-destination channel is selected, this field will be highlighted. If you
want to defeat the selected move-destination channel, press the DESTINATION CH field.
NOTE
In the case of the QL1, faders that do not exist on the model will not be shown.
3 MOVE button
Executes a move operation. After selecting the move-source channel and
move-destination channel, the channel settings move from the move-source to the
move-destination. The settings of all channels between the move-source and
move-destination will shift toward the move-source by one channel.
4 CLOSE button
Press this button to close the window and return to the previous screen.
Initializing the parameters of a channel
You can restore the parameters of a channel to an initialized state. This operation can be
performed on any channel(s).
CH JOB
menu
Function
Access Area
STEP
1. In the Function Access Area, press the CH JOB button.
2. Press the DEFAULT button in the CH JOB menu.
3. Press the [SEL] key of the channel(s) to be initialized to make it light (multiple
selections are allowed).
4. Press the DEFAULT button to execute the Initialization.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
