176
T h e P a t t e r n J o b s
10 : Erase Event
Erases all note and event data from the specified measure or range
of measures in the specified track. An erase operation leaves the specified
measures intact but blank.
The “TR” parameter selects the track to be affected by the Erase
Event job: D1, D2, PC, BA, C1, C2, C3, C4.
The “M” parameters above the graphic bar are used to specify the
first measure:beat and last measure:beat of the range to be erased.
After setting the parameters as required press [ENTER] to execute
the Erase Event job. The metronome icon will appear on the display while
the data is being processed, then “Completed” will appear briefly when
the job is done. Press the [EXIT] key to return to the job list, or a mode key
to go directly to the selected mode.
■
NOTE
• The Erase Event job erases the data from the specified measures only in the
specified track. Also, the data is erased but the measures remain intact (i.e. the
subsequent measures are not moved back). After an erase operation you can
record new material in the resulting blank measures as required.
First beat.
First measure. Last measure.
Last beat.
To Next Page
Loading...
Need help?
General
