184
T h e P a t t e r n J o b s
16 : Get Phrase
Copies the data from the specified range of measures in the speci-
fied track of a specified song to the specified phrase.
The “Song” parameter selects the source song — i.e. the song
from which the data is to be copied: “01” … “20”.
The “TR” parameter selects the song source track — i.e. the track
from which the data is to be copied: “01” … “16”.
The “M” parameters above the upper graphic bar are used to
specify the first measure and last measure of the range to be copied.
The lower “TR” parameter specified the track to which the data is
to be copied: D1, D2, PC, BA, C1, C2, C3, C4.
After setting the parameters as required press [ENTER] to execute
the Get Phrase job. The metronome icon will appear on the display while
the data is being processed, then “Completed” will appear briefly when
the job is done. Press the [EXIT] key to return to the job list, or a mode key
to go directly to the selected mode.
■
NOTE
• The Get Phrase job is a convenient way to create new phrases by copying a few
appropriate measures from songs.
• If the destination track already contains data, the copied data will erase and replace
the previous phrase data.
First measure.
Last measure.
To Next Page
Loading...
Need help?
General
