186
T h e P a t t e r n J o b s
18 : Copy Track
Copies all data from the specified track in the specified section of
the specified style to any other specified track in the specified section of
the specified style.
The upper “Style” parameter specifies the source style: “001” …
“128”, “U01” … “U64”.
The upper “Section” parameter specifies the source section:
“Intro”, “MainA”, “MainB”, “FillAB”, “FillBA”, “Ending”.
The upper “TR” parameter selects the source track — i.e. the track
from which the data is to be copied: D1, D2, PC, BA, C1, C2, C3, C4.
The lower “Style” parameter specifies the destination style: “U01”
… “U64”.
The lower “Section” parameter specifies the destination section:
“Intro”, “MainA”, “MainB”, “FillAB”, “FillBA”, “Ending”.
The lower “TR” parameter selects the destination track — i.e. the
track to which the data is to be copied: D1, D2, PC, BA, C1, C2, C3, C4.
After setting the parameters as required press [ENTER] to execute
the Copy Track job. The metronome icon will appear on the display while
the data is being processed, then “Completed” will appear briefly when
the job is done. Press the [EXIT] key to return to the job list, or a mode key
to go directly to the selected mode.
■
NOTE
• If the destination track already contains data, the copied data will erase and replace
the previous data.
To Next Page
Loading...
Need help?
General
