10 HANDLING THE BUCKET
10.1 Machine stability when using with a bucket or an
accessory
• The maximum weight when in use in bucket mode or with accessories ensure machine dy-
namic stability in use. It corresponds to the maximum weight allowed at the end of the empty
arm.
• This weight is determined for the machine on a flat and firm ground under the most unfavour-
able conditions and is indicated in the table below.
1 Lifting SV26 Cabin, page 171
1150 mm 1400 mm
370 330
405 380
2 Lifting SV26 Canopy, page 172
1150 mm 1400 mm
330 300
380 345
• It must absolutely be taken into account by the operator before using the machine for excava-
tion, levelling operations or in working conditions with the accessories.
• Depending on the machine configuration (arm length, presence of a counterweight…) and
working conditions, the operator must make sure that :
– The equipment and accessories selection is made according to the nature of the task to be car-
ried out and according to the machine's stability limits.
– the total weight of the quick coupler, the accessories used (bucket, hydraulic hammer...) and
the load handled does not exceed the maximum weight allowed.
DANGER
Any excess can lead to a loss of stability of the machine and tip it over. YANMAR CON-
STRUCTION EQUIPMENT EUROPE S.A.S. accepts no responsibility in case of non
compliance with the safety instructions described in this chapter.
99
To Next Page
Loading...
Need help?
General
