2 Usage precautions
73
1. Lower the lock lever.
2.
Set the starter key to ON position.
3. Use the joysticks to lower the boom and place the accessory or load on the ground.
4. Raise the lock lever.
5. Turn the key to OFF position to switch off the engine and disconnect the electrical circuit.
Remove the key from the ignition.
2.3.6 Working on a slope
• Make sure that the machine does not lose its balance
and tip over when rotating the upper structure or when ro-
tating equipment on a slope.
• Do not pivot the upper structure with a load in the
bucket.
• If the rotation cannot be avoided, provide a bank to
keep the machine as horizontal as possible. Then turn the
upper structure.
Note
For the maximum acceptable slope: :
1 Specifications, page 165
2.3.7 Working in an area covered with snow
• Ground covered with snow and icy roads are dangerous as the machine may slip, even on a
slight incline. Drive the machine at reduced speed; do not stop or turn suddenly.
• Remove the snow carefully as verges or other potential dangers may be buried beneath the
snow.
To Next Page
Loading...
Need help?
General
