2 Maintenance precautions
132
2.1.3 Place a warning label
WARNING
Не манипулирайте лостовете за управле-
ние по време на поддръжката. Mainte-
nance personnel may be seriously injured.
Place a MAINTENANCE IN PROGRESS la-
bel on the machine and on the joysticks.
2.1.4 Establish a safety perimeter
• Anyone who is not part of the maintenance team must be kept away from the working area.
• Pay attention to the safety of people nearby, notably during milling or welding operations or
when a hammer is used.
2.1.5 Keep the machine clean
• Cleaning the machine will enable you to detect any
leaks and defective parts quickly.
• Especially clean the filler cap, the vent hole and oil
level glass gauge and prevent dust from mixing there.
• Spots of oil or grease or dispersed part fragments are dangerous and may cause slipping.
• Any water that gets into the electrical system may cause it to malfunction, leading to defec-
tive operation of the machine. This also risks causing short circuits that may cause a fire or elec-
tric shock.
• Do not spray any vapour directly onto the sensors or connectors.
• Do not use harsh chemicals to clean the machine, as these affect the visual and technical char-
acteristics of the machine components.These products may also deteriorate the rigidity of the
tank.
• Do not spill any water onto the dashboard.
• Do not spray water directly at high pressure onto the radiator or the oil radiator.
• Do not point the pressure washers on the electrical connectors.
To Next Page
Loading...
Need help?
General
