7 Options
38
Position holding button
To use the position holding button:
3= Position holding button
1. Operate the accessory with the proportio-
nal roller. (1)
2. Press the position holding button. (3)Re-
lease the proportional roller. (1)
The proportional roller control pressure is
blocked and the LED on the corresponding
joystick comes on.
3. The accessory operation is maintained
and the accessory is operated at the rate set by
the knob. (2)
4. Press the position holding button again to
return the pressure to its starting level.
CAUTION
Do not use the position holding with bucket tilting, you would risk damaging the machi-
ne's hydraulic circuit.
7.3 PTO line 2
Use the proportional roller on the left joystick to use the accessory mounted on the PTO's second
line.
PTO 2 may be associated with a knob to make it an adjustable proportional PTO line.
P.T.O. switch
• Use the proportional roller to adapt the dual effect P.T.O. rate.
1= Proportional roller
Adjustable proportional PTO
• The adjustable proportionality allows better P.T.O flow control by combining a knob with the
proportional roller.
To Next Page
Loading...
Need help?
General
