12 ACCESSORY CHANGE BY DIRECT COUPLING
12.1 Dismantling the accessory
A & B = Bucket or attachment bore
1. Place the machine on flat ground.
2. Place the accessory at about 5 cm above the ground.
3. Stop the engine.
4. Clean all the parts.
5. Remove the swivel pin from the A bore and the swivel pin from the B bore.
IMPORTANT
• Protect the various elements from dirt and dust.
• Take care not to damage seals on each bushing side.
• Verify the good state of o-rings. Replace them if they are damaged.
107
To Next Page
Loading...
