Yealink SIP-T41S Administrator's Guide

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
126
Permitted
Values
-1-Do not modify the configuration.
0-Disabled, the backlight will be turned off after the handset is idle for about 10 seconds.
1-Enabled, the backlight will be turned off after the handset is idle for about 30 minutes.
Default
-1
Supported
Devices
W53H, W56H
Handset UI
OK > Settings > Display > Display Backlight > In Charger
Parameter
custom.handset.backlight_out_of_charger.enable <y0000000000xx>.cfg
Description
It enables or disables the handset backlight to be on for about 30 minutes when it is not charged.
Note: It will take effect on all handsets that are registered on the same phone. It works only if “stat-
ic.auto_provision.handset_configured.enable” is set to 1 (Enabled).
Permitted
Values
-1-Do not modify the configuration.
0-Disabled, the backlight will be turned off after the handset is idle for about 10 seconds.
1-Enabled, the backlight will be turned off after the handset is idle for about 30 minutes.
Default
-1
Supported
Devices
W53H, W56H
Handset UI
OK > Settings > Display > Display Backlight > Out Of Charger
Handset Keypad Light
You can enable the handset keypad light to light up the keypad when any key is pressed. This helps you dis-
tinguish keys from each other in a dark environment.
Topic
Handset Keypad Light Configuration
Handset Keypad Light Configuration
The following table lists the parameter you can use to configure the handset keypad light.
Parameter
custom.handset.keypad_light.enable <y0000000000xx>.cfg
Description
It enables or disables the handset to turn on the keypad light (digital key, # key, * key, TRAN key, and
Mute key) when any key is pressed.
Note: It will take effect on all handsets that are registered to the same phone. It works only if “stat-
ic.auto_provision.handset_configured.enable” is set to 1 (Enabled).
Permitted
Values
0-Disabled
1-Enabled
Default
1
Supported
Devices
W53H, W56H
Handset UI
OK > Settings > Display > Keypad LED

Yealink SIP-T41S Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Keypad illumination	Yes
Wi-Fi	No
Networking standards	IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Supported network protocols	SIP v1, SIP v2, LLDP/CDP/DHCP, OpenVPN, IEEE802.1X, IPv6, FTP/TFTP/HTTP/HTTPS
Volume control	Digital
Number of programmable keys	6
Lines quantity	6 lines
Phonebook capacity	1000 entries
Dual-Tone Multi-Frequency (DTMF) modes	In-band, Out-of band, SIP info
Input frequency	50/60 Hz
AC adapter input voltage	100 - 240 V
AC adapter output current	1.2 A
AC adapter output voltage	5 V
Display diagonal	2.7 \
Display resolution	192 x 64 pixels
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	10 - 95 %
Voice codecs	CNG, G.711Mu, G.711a, G.723.1, G.726, G.729ab, VAD, iLBC
Certification	CE
Cables included	LAN (RJ-45)
Number of handles included	1 pc(s)
Harmonized System (HS) code	85171800

Weight and Dimensions

Depth	189 mm
Width	212 mm
Height	175 mm
Package depth	223 mm
Package width	246 mm
Package height	120 mm