User Guide for the SIP-T48G IP Phone
98
System Customizations
Headset Use
If you want to use a wired headset, physically connect your headset to the phone and activate
the headset mode for use. For more information on physically connecting a headset, refer to
Phone Installation on page 18.
If you want to use a wireless headset, insert the Bluetooth USB dongle BT40 into the USB port at
the back of the IP phone. For more information on using a Bluetooth headset, refer to Bluetooth
on page 100.
This section provides an introduction to wired headset use.
Note
Headset Mode Activation/Deactivation
To activate the headset mode:
1. Press on the phone.
The HEADSET key LED illuminates solid green, and the icon appears on the status bar
of the touch screen.
When you tap the line key or the Answer soft key to answer an incoming call, the call is
connected to your headset automatically. For more information on using the headset to
answer a call, refer to Answering Calls on page 136.
With the handset on-hook, enter the desired number and tap Send, the phone will then
place a call using the headset automatically. For more information on using the headset to
place a call, refer to Placing Calls on page 134.
To deactivate the headset mode:
1. Press again on the phone.
The HEADSET key LED goes out, and the icon disappears from the touch screen.
Headset Prior
You can use headset in priority when headset prior feature is enabled. This feature is especially
useful for permanent or full-time headset users.
If both a Bluetooth headset and a wired headset are connected, only the Bluetooth headset can
be used.
To use headset, make sure the headset mode is enabled. Contact your system administrator for
To Next Page
Loading...
Need help?
General
Weight and Dimensions
