Yealink SIP-T48G User Manual

User Guide for the SIP-T48G IP Phone
188
Configuring Transfer Mode on DSS Key
When there is an active call on the IP phone, you can handle the active call differently using a
BLF key. The phone behavior depends on the configuration of transfer mode via DSS key with
the BLF key.
To configure the transfer mode on DSS key via web user interface:
1. Click on Features->Transfer.
2. Select the desired transfer mode from the pull-down list of Transfer Mode via Dsskey.
 If you select Blind Transfer, tap the BLF key to blind transfer the call to the
monitored user.
 If you select Attended Transfer, tap the BLF key to dial out the monitored phone
number and then perform an attended or a semi-attended transfer.
 If you select New Call, tap the BLF key to place a new call to the monitored user.
The original call is placed on hold.
3. Click Confirm to accept the change.
Note
Using BLF Feature on the IP Phone
You can use the BLF key in the following ways:
 Place a call to the monitored user.
 Transfer a call to the monitored user.
 Pick up an incoming call of the monitored user.
Placing a Call to the Monitored User
You can tap a BLF key to dial out the monitored phone number when the monitored line is idle.
To place a call to the monitored user when the IP phone is idle:
1. Tap the BLF key.
The IP phone dials out the phone number of the monitored user.
Transfer Mode on DSS Key is also applicable to BLF list feature.

Yealink SIP-T48G Specifications

General

Expansion module support	Yes
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Volume control	-
Display diagonal	7 \
Display resolution	800 x 480 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
AC adapter input voltage	100 - 240 V
Number of handles included	1 pc(s)

Weight and Dimensions

Width	266 mm
Height	185 mm