Yealink SIP-T48G User Manual

Basic Call Features
169
5. Click Confirm to accept the change.
Note
To set up a network conference call:
1. Place a call to the first party.
2. Tap the Conference soft key to place a new call.
The active call is placed on hold.
3. Enter the number of the second party and then press , , or tap the Send soft key.
4. When the second party answers the call, tap the Conference soft key to add the second
party to the conference.
5. Tap the Conference soft key to place a new call.
The conference call is placed on hold.
6. Enter the number of the new party and then press , , or tap the Send soft key.
7. When the new party answers the call, tap the Conference soft key to add the new party to
the conference.
8. Repeat steps 5 to 7 until you have added all intended parties.
The procedures to set up a network conference call on specific servers may be different from
introduced above. Contact your system administrator for more information.
Call Park/Retrieve
You can use call park feature to place a call on hold, and then retrieve the call from another
phone in the system (for example, a phone in another office or conference room). You can park
an active call by tapping the Park soft key or pressing call park key (if configured) on the phone.
If the call is parked successfully, there is a voice prompt confirming that the call was parked. You
can retrieve the parked call by pressing the Retrieve soft key or the retrieve park key (if
configured). If the parked call is not retrieved within a period of time defined by the system, the
phone performing call park will receive the call back.
Note
The IP phone supports call park feature under the following modes:
 FAC mode: park the call to the local extension or a desired extension through dialing the
park code.
 Transfer mode: park the call to shared parking lot through performing a blind transfer to
a call park number (call park code).
Network conference is configurable via web user interface only.
Call park is not available on all servers. Contact your system administrator for more information.

Yealink SIP-T48G Specifications

General

Expansion module support	Yes
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Volume control	-
Display diagonal	7 \
Display resolution	800 x 480 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
AC adapter input voltage	100 - 240 V
Number of handles included	1 pc(s)

Weight and Dimensions

Width	266 mm
Height	185 mm