Yealink SIP-T48G User Manual

User Guide for the SIP-T48G IP Phone
100
To enable dual headset via web user interface:
1. Click on Features->General Information.
2. Select Enabled from the pull-down list of Dual Headset.
3. Click Confirm to accept the change.
Note
Bluetooth
The SIP-T48G IP phone supports Bluetooth. Bluetooth enables low-bandwidth wireless
connections within a range of 10 meters (32 feet). The best performance is in the 1 to 2 meters
(3 to 6 feet) range.
You can activate/deactivate the Bluetooth mode on the phone, and then pair and connect the
Bluetooth device (Bluetooth headset or Bluetooth-Enabled mobile phone) with your phone. If
you connect your Bluetooth-Enabled mobile phone to the IP phone, you can synchronize the
mobile contacts to the IP phone. You can scan and pair up to 60 Bluetooth devices with your
phone. However, only one device can be connected at a time. You can also disconnect and
delete your Bluetooth device from the phone.
Note
The Bluetooth device will disconnect from your phone in the following introduced scenarios:
Dual headset is configurable via web user interface only.
Ensure that the Bluetooth USB dongle BT40 is properly connected to the USB port at the back of
the IP phone. For more information, refer to Phone Installation on page 18.
Not all mobile phone supports this function. Contact your system administrator for more
information.

Yealink SIP-T48G Specifications

General

Expansion module support	Yes
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Volume control	-
Display diagonal	7 \
Display resolution	800 x 480 pixels
Lines quantity	- lines
Phonebook capacity	1000 entries
Number of VoIP accounts	6
AC adapter input voltage	100 - 240 V
Number of handles included	1 pc(s)

Weight and Dimensions

Width	266 mm
Height	185 mm