YOKOGAWA Daqstation DX2000 User Manual

1-57
IM 04L42B01-01E
Overview of Functions
1
2
3
4
5
6
7
8
9
10
11
12
13
App
Index
SystemDisplay
Displays the total number of inputs on the DX, the size of the internal memory, the
communication functions, the external storage drive, the options, the remote controller
ID, the operation of the devices connected to the USB port (/USB1 option), the MAC
address, and the firmware version number.
For the operating procedure, see section 2.5.
Language
The displayed language can be set to English, Japanese, German, French, or, Chinese.
For the setting procedure, see section 2.6.
VGAOutputTerminal(/D5Option)
Shows the DX display on a monitor through the RGB output.
24 VDC PowerSupplyforTransmitter(/TPS4or/TPS8Option)
Provides 24-VDC power supply to up to four (/TPS4) or eight (/TPS8) two-wire system
transmitters. The measured values of the transmitter correspond to a current signal of
4 to 20 mA on the same cable. Therefore, the signal can be connected to the DX input
terminal and displayed.
–
+
+
–
Transmitter
Current
DX
Transmitter power
supply output terminal
Input terminal
Shunt resistor: 250 Ω
EasyTextEntryOption(/KB1and/KB2Options)
You can control the DX using the keys on the remote control terminal.
• SettheremotecontrollerIDontheDXandtheIDnumberontheremotecontrol
terminal to the same value.
• Youcansetavaluebetween0and31fortheremotecontrollerIDandIDnumber.
• BychangingtheIDnumberontheremotecontrolterminal,youcancontrolDXswith
different remote controller IDs from a single remote control terminal.
For the operating procedure, see section 2.10.
Light-receiving
section
Infrared signal
output section
1.10OtherFunctions

YOKOGAWA Daqstation DX2000 Specifications

General

Brand	YOKOGAWA
Model	Daqstation DX2000
Category	Recording Equipment
Language	English