Replacing full-continuous motor oil filte
Pouring oil to engine
The full-flow oil filter (a) is located on the lef
-hand side of
the engine and is accessible after the bonnet has been
lifted. The filter must be changed each time the motor oil
renewal is carried out.
1. Put a catch reservoir for the drained oil under the full-
flow oil filter
2. Loosen the oil filter and screw it off using appropriate
tools
3. Before screwing on a new filter clean the packing
surface of the body (1) and that of the filter (2)
4. Smear the engine fill oil on the rubber packing of the
new oil filter and screw on the filter
5. Once the packing has sit down on the contact surface
tighten up the filter manually
For tigtening the filter with a special tool
a tightening moment of 15-17 Nm is required.
6. Check tightness after the engine has started up.
NM14D008
The engine is equipped with two filling holes
On the upper side of the engine (a)
On the left-hand side of the engine above the oil level
gauge (b)
While filling oil choose a hole which best suits the tractor
equipment.
1. Fill the prescribed amount of motor oil through the filling
hole
2. Check the oil contents using the gauge
3. Start up the engine and keep it running for 2 or
3 minutes with cca 800 revolutions per minute.
4. After the engine has been stopped and the surface is
calm, check up oil contents with the gauge (1) and make
a tightness check of the filter, draining plugs and other
oints
NM14D009
To Next Page
Loading...
Need help?
General