Replacement of filter element of hydrostatic control
The oil filter is located on the left side of the tractor in front
of the fuel tank.
Prior to the replacement of the filter element put
a suitable vessel for catching the dripping oil under
the tractor.
1. release and unscrew the filter element (1) with an
appropriate tool
2. clean the sealing surface of the filter body prior to
screwing a new filter element
3. lubricate the rubber sealing of the new filter element
with oil and screw the elemen
4. after a contact of the sealing to the contact surface
tighten the filter element (1) by hand
5. check the oil level in the gearbox, add oil if necessary
MCL18N033
To Next Page
Loading...
Need help?
General