Wiring with the logic relay
132
1SVC 440 795 M0100
Wiring a text display
You integrate a text display into your circuit in the form of a
contact and coil.
The coils and contacts have the following meanings:
The text display does not have a parameter display in the
PARAMETER menu.
Retention
The texts D1 to D8 can be operated with retentive actual
values (contacts).
If the text displays are retentive, the actual value is retained
when the operating mode changes from RUN to STOP as
well as when the power supply is switched off.
When the logic relay is restarted in RUN mode, the text
displays D1 to D8 continue with the retentively stored actual
value.
h
Compatibility with AC010
If you wish to load an existing AC010 circuit diagram, the
available text display functions are retained. The text
display operates in CL-LSR/CL-LST and CL-LMR/CL-LMT in
the same way as in AC010.
i5-------ÄD2
i6-------ÄD3
D2u------ÄT5
D3k
Contact Coil
D1 to D16 Coil of the corresponding text
display is triggered
Ä, Å, è, ^, ä,
S, R
D1 to D16
If a coil is triggered, the text is
shown in the display.
To Next Page
Loading...
Need help?
General
