Rockwell Automation Publication 2080-UM002K-EN-E - March 2019 21
About Your Controller Chapter 2
After the new IP address is configured and applied, the controller will disconnect
from Connected Components Workbench if communication is through
Ethernet.
You can verify that the IP address has changed after performing RMCC by
looking at the Ethernet settings for the controller.
RMCC EtherNet/IP Example – Verify Address Change
Agency Certifications
• UL Listed Industrial Control Equipment, certified for US and Canada.
UL Listed for Class I, Division 2 Group A,B,C,D Hazardous Locations,
certified for U.S. and Canada.
• CE marked for all applicable directives
• RCM marked for all applicable acts
• KC - Korean Registration of Broadcasting and Communications
Equipment, compliant with: Article 58-2 of Radio Waves Act, Clause 3.
Compliance to European
Union Directives
This product has the CE mark and is approved for installation within the
European Union and EEA regions. It has been designed and tested to meet the
following directives.
Micro830 controllers do not support Run Mode Configuration Change
using EtherNet/IP.
You should not perform IP address changes continuously. Allow an
interval of at least six seconds before performing the next IP address
change in order for duplicate address detection to work properly.
To Next Page
Loading...
Need help?
General
