AudioCodes MP-20 Series User Manual

User's Manual 100 Document #: LTRT-50614
MP-20x Multimedia Home Gateway
9.6 Voice Menu Guidance
The FXS voice menu can be used to query a current firmware version and query or modify
basic network configuration parameters, using a standard touch-tone telephone connected
to one of the FXS ports.
9.6.1 Configuring Voice Menu
Voice Menu can be configured for through the Web interface or the CLI.
9.6.1.1 Configuring Voice Menu through the Web Interface
 To configure Voice Menu through the Web Interface:
1. In the ‘Voice over IP’ screen click on ‘Services’ tab
2. Under ‘Voice Menu’ section Select ‘Enabled’ option to enable the Voice Menu feature.
3. Set Password – this allows to modify WAN Ethernet network settings using Voice
Menu (Admin level)
4. Click OK
Figure 1-1: Voice Menu Configuration
9.6.1.2 Configuring Voice Menu through the CLI
 To configure Voice Menu through the CLI:
1. Open a Telnet connection to the MP-20x device (Default: telnet 192.168.2.1)
2. Log in with administrator privileges (Default: admin/admin)
3. Run the following commands under the MP20x> prompt:
conf set /voip/services/voice_menu/enabled 1
conf set_obscure voip/services/voice_menu/password <password>
conf reconf 1
9.6.1.3 Voice Menu Configuration Parameters
Table 1-1: Voice Menu Configuration Parameters
The table below lists the configuration parameters that can be viewed and modified using
the voice menu:
Item Number at
Menu Prompt
Description
1
WAN IP address
2
Subnet Mask
3
Default Gateway IP address
4
Current firmware version

AudioCodes MP-20 Series Specifications

General

Brand	AudioCodes
Model	MP-20 Series
Category	Adapter
Language	English