User's Manual 280 Document #: LTRT-50614
MP-20x Multimedia Home Gateway
16.6 Selecting Regional Settings for Analog Lines
The behavior and parameters of analog telephones lines vary between countries. The set
of Call Progress Tones, the protocol used for caller ID and the analog line impedance are
all location-specific. The device enables users to select the country they reside in and the
device automatically selects the correct regional settings.
To select your present location:
1. On the 'Advanced' screen, click the Regional Settings icon; the 'Regional
Settings' screen appears.
2. Select the country from the drop-down list. If your current location is not listed, contact
your service provider.
Figure 16-14: Regional Settings Screen
3. Click OK.
4. Reboot the device for your settings to take effect.
The following is an example of the relevant Telnet parameters:
rg_conf/voip/regional_settings/selected_country=USA
rg_conf/voip/regional_settings/rg_conf_country=USA
rg_conf/voip/regional_settings/use_rg_conf_configuration=0
rg_conf/voip/regional_settings/caller_id_standard=0
rg_conf/voip/regional_settings/caller_id_timing=0
To Next Page
Loading...
Need help?
General
