AudioCodes MP-20 Series User Manual

User's Manual 14. Remote Device Management
Version 4.4.3 229 MP-20x Multimedia Home Gateway
14.4.3.2 Configuring the Device via SNMP
The acMP20xConfig MIB section is structured in a similar hierarchy as the device's Web
GUI. Each parameter in the MIB has a matching parameter in the Web GUI and a matching
parameter in the gateway’s configuration file. The MIB file defines the valid range and the
default value for each parameter. Typically, the customer integrates the MP20x MIB into
the customer's Network Management System (NMS) to automate the configuration
process.
Note: A special MIB object is defined to allow the device firmware upgrade triggered by
SNMP. The object acMP20xRemoteUpdate triggers a remote upgrade from the SNMP-
configured URL.
14.4.3.3 Status Monitoring of System and Network Interfaces via SNMP
SMNP can be used to monitor the status of the device. Status monitoring of the system
and network interfaces can be done via the standard MIB-II
(iso(1).org(3).dod(6).internet(1).mgmt(2).mib-2(1)). The following table shows some of the
information elements available via MIB-II:
Table 14-17: Table 3-13: Information Elements Available via MIB-II
Section Available Information
system
 Description
 Version Information
 Up-time
interfaces Information per network interface:
 Description
 Type
 Speed
 MAC address
 Traffic statistics
 Errors
ip
Assigned IP addresses and IP-related parameters
icmp, udp, tcp
Transport-protocol specific statistical information
ifMIB
Information about network interfaces per RFC 2233

AudioCodes MP-20 Series Specifications

General

Brand	AudioCodes
Model	MP-20 Series
Category	Adapter
Language	English