User's Manual 126 Document #: LTRT-50614
MP-20x Multimedia Home Gateway
g. To match packet or data length, select the ‘Length’ check box, and then enter the
data or packet length.
h. To match connection duration, select the ‘Connection Duration’ check box, and
then enter the duration of the connection (greater or less than).
i. To match connection size, select the ‘Connection Size’ check box, and then enter
the connection size.
4. Under the Operation group, configure the QoS operation:
a. Select the ‘Set DSCP’ check box to mark a DSCP value on packets matching this
rule and then enter the hexadecimal value of the DSCP.
b. Select the ‘Set Priority’ check box to add a priority to the rule and then select the
priority level (where 0 is the lowest and 7 the highest). This sets the priority of a
packet on the connection matching the rule, while routing the packet.
c. Select the ‘Tx Class Name’ check box, and then select the class name that you
defined.
d. From the ‘Apply QoS on’ drop-down list, select whether you want to apply the
QoS rule on the connection or on the packet.
5. Select the ‘Log Packets Matched by This Rule’ check box to log the first packet from a
connection that matches by this rule.
6. From the ‘Schedule’ drop-down list, select the time segments during which the rule
may be active. By default, the rule is always active (i.e., ‘Always’). If you have defined
Scheduler rules (see Section 5.6.1 on page 55), then these are also displayed as
options. To define a new one Scheduler rule, select ‘User Defined’.
7. Click OK to save the settings.
To Next Page
Loading...
Need help?
General
