114
BSR
Activating the BSR Sewing Function:
1. With the Foot Control
plug in the foot control ►
lower the presser foot ►
start the BSR mode by pressing the foot control ►
a red light appears on the presser foot ►
the foot control must be pressed continuously during ►
sewing
the speed of the sewing computer will be regulated by ►
the movement of the fabric
by releasing the foot control the BSR mode stops ►
2. With the Start - Stop - Button
remove the foot control ►
lower the presser foot ►
start the BSR mode by pressing the Start-Stop-button ►
a red light appears on the presser foot ►
the speed of the sewing computer is regulated by the ►
movement of the fabric
by re-pressing the Start-Stop-button the BSR mode ►
stops
Deactivating the BSR Sewing Function
by using the Start - Stop - Button
Mode 1:
if the fabric is not moved for approx. 7 seconds, the ►
BSR mode is deactived and the red light on the presser
foot goes off
Holding the Work
hold and guide the taut fabric with both hands ►
abrupt movements of the fabric (slowing down, speed- ►
ing up respectively) can result in slightly too short or too
long stiches
continuous movement of the fabric (no abrupt move- ►
ments) under the foot will provide best results
move the fabric in one direction for best results ►
Application Example:
BSR With Zig-zag Stitch no. 2
the zig-zag stitch can be used for thread painting or ►
fabric embellishment for example
areas can be filled and forms or pictures created ►
BSR Function Deactivation
pull out the plug of the BSR presser foot connection ►
cable on the sewing computer. The straight stitch no. 1
is active
remove the BSR foot ►
Mode 2:
if the stitching process is ended by no longer moving the ►
fabric, one additional stitch is made depending on the
needle position. The sewing computer always stops with
the needle up, even if the arrow on the display points
down
To Next Page
Loading...
Need help?
General
