2222
Due to the width of the stitch plate hole the outer feed-dog
rows are relatively far apart.
When sewing corners the fabric does not feed well, since
only a part of the fabric is on the feed-dog.
Correct this by placing one or more plates close to the
edge of the fabric.
Sewing Corners
Sewing with the Height Compensation Tool
Preparation
The feed-dog works accurately if the presser foot is level.
If the presser foot is at an angle when sewing over a thick
seam, the feed-dog cannot grip. The fabric may jam.
To level the presser foot as required, place one, two or
three height-compensating plates behind the needle under
the presser foot.
To level the front of the foot, place one or more plates
under the right of the presser foot close to the needle.
Sew until the presser foot has passed the thick area and
remove the plates.
To Next Page
Loading...
Need help?
General
