Bernina 830LE - Automatic Thread Cutter; Securing Stitches after Thread Is Cut; Sewing

36
Setup Program
Sewing
Motor Speed
alter maximum sewing speed ► 1
the number in the bar is the stitches per minute; the ►
basic value is indicated by a dark bar
Thread Tension
alter the basic setting (0) of the upper thread tension ► 2
by plus or minus 20%
0 =
basic settings
10 = +10%
20 = +20%
-10 = –10%
-20 = –20%
Securing stitches after thread is cut
function ► 3 is active = standard
if the automatic thread cutter is used to cut the threads, ►
4 securing stitches will be stitched when resuming
sewing
function is inactive = no securing stitches will be stitched ►
1
2
3
S
e
f
►
i
►
4
s
f
►
the tension alteration affects all stitches and ►
stitch patterns and is saved even when the
sewing-/embroidery computer is switched
off
►
4
5 6
Automatic Securing Program
the number and type of the securing stitches can be ►
programmed
standard = four securing stitches in the same place ►
select function ► 4 for forward securing stitches
3-6 securing stitches can be programmed ►
Automatic Thread Cutter
if function ► 5 is activated, the upper and lower thread are
automatically cut after sewing
Raise Presser Foot
if function is activated ► 6 the presser foot is raised after
securing
if function is not activated, the presser foot stays down ►