24.6
# Operations with powertrain cradle
installed
L
Note:
Operations identified by
#
can also be carried out
with the powertrain cradle installed.
# Variator replacement
Removing variator
Removing variator driven plate
To enhance clarity some of the illustrations portray
the components with the powertrain cradle removed
•
Remove vent cover
•
Remove variator cover
e
Attention:
Make sure that belt and belt pulleys remain free of
oil and grease!
•
Release nut from clutch drum using retainer,
BMW No. 11 7 521
•
Remove clutch drum, using a puller if necessary
•
To relieve tension on belt, turn outer plate (arrow)
of driven variator counterclockwise by hand
while simultaneously pressing it against inner
plate
•
The purpose is to move belt onto small-diameter
and hold the two plates apart
•
Remove driven variator with belt from variator
shaft and out of driven variator
11 7 521
C1110381
C1110390
C1110400
To Next Page
Loading...
