00.59
When installing:
•
Observe installation instructions for lubricated
(
a
00.56) and unlubricated variator (
a
00.58)
•
Spray shaft as necessary
Fluids and lubricants:
Shaft ................................ Klüber paste 46 MR 401
Mount for drive variator .................... LOCTITE 243
e
Attention:
Make sure that belt is not trapped between the belt
plates!
X
Torque specification:
Mount, drive variator
(+ LOCTITE 243)........................................... 60 Nm
Variator cover............................................... 10 Nm
Vent cover...................................................... 9 Nm
Checking wheel bearing float
(Inspection III)
L
Note:
Check bearing float with cold bearing only.
•
Take the weight off the front/rear wheel
•
Tilt the front/rear wheel back and forth on the
axle
•
It should not be possible to feel any lost motion
•
If play is detected in the wheel bearings, replace
them
a
................................................... See Group 36
To Next Page
Loading...
Need help?
General
