24.21
When installing:
L
Note:
Grease one side of a thrust washer for intermediate
shaft and attach it to side of large gear!
•
Install seal plug with copper seal
•
Oil stub of intermediate shaft and install
•
Position variator shaft in cover
•
Position output shaft in grooved ball bearing
•
Mount second thrust washer on intermediate
shaft
•
Install seal
Fluids and lubricants:
shaft oil seal seats............ Klüber paste 46 MR 401
Shaft seats ....................... Klüber paste 46 MR 401
X
Torque specification:
Drain plug..................................................... 20 Nm
Filler plug ....................................................... 5 Nm
Gearbox cover ............................................. 11 Nm
# Replacing housing shaft oil seal on
output shaft
L
Note:
Additional work necessary if powertrain cradle is to
remain installed:
- Remove rear wheel (
a
36.9)
- Use strut support
– Remove complete variator assembly (
a
24.6)
– Remove gearbox cover (
a
24.20)
– Removing gearbox shafts (
a
24.20)
•
Pry out shaft oil sealing ring, using an angled
screwdriver with a second screwdriver for lever-
age, or with screwdriver resting on housing
C1110720
C1110730
To Next Page
Loading...
Need help?
General
