31.15
Replace guide bush
– Remove telescopic tube cross brace with tele-
scopic tubes (
a
31.11)
•
Remove front wheel
– Remove telescopic tube seal (
a
31.13)
•
Place support ring,
BMW No. 36 6 610,
on seal
holder
•
Extract guide bush (arrow) with puller,
BMW No. 00 8 572,
and internal extractor,
BMW No. 00 8 563
L
Note:
Residual oil from telescopic fork can be allowed to
run out!
Plastic tube liners are mounted loose within tele-
scopic tube!
•
Turn around telescopic fork and remove plastic
tube liners (2x)
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
e
Attention:
Do not tilt guide bush during installation!
•
Place telescopic fork on a solid support surface
and install new guide bush with drift punch,
BMW No. 31 5 712
, continuing until it seats firm-
ly
– Install telescopic tube seal (
a
31.13)
•
Install front wheel
– Install telescopic tube cross brace with
telescopic tubes (
a
31.18)
C1310270
00 8 572
36 6 610
00 8 563
31 5 712
C1310310
To Next Page
Loading...
Need help?
General
