63.10
63 99 321
Replacing rear left/right turn
signal bulb
The procedure for the left turn signal is described
below. The procedure for replacing the right turn
signal is essentially the same.
e
Attention:
Always switch off the ignition before changing bulbs!
L
Note:
Never touch inside of reflector and glass on bulbs
with bare fingers!
•
Remove fastener (1)
•
Remove lens (3)
•
Press bulb (2) forward and disengage by turning
it counter-clockwise
•
Remove bulb
When installing:
•
Installation is the reverse of the removal proce-
dure
X
Torque specification:
Lens attachment ............................................ 2 Nm
Rear lights
63 21 380
Replacing taillamp cluster
– Remove the rear storage compartment
a
....................................................See Group 46
•
Open cable ties (arrows)
•
Disconnect plug (1)
•
Remove fastener (arrows)
•
Remove taillamp cluster
When installing:
•
Installation is the reverse of the removal proce-
dure
X
Torque specification:
Taillamp attachment....................................... 5 Nm
C1630010
1
2
3
C1630120
1
C1630130
To Next Page
Loading...
Need help?
General
