Messages regarding printing or adjusment
Messages regarding printing or adjusment
Use another paper .
Cause Corrective Action
For automatic Printhead adjustment, we recommend
using a type of paper that you often use, other than
lm.
( → P .584)
The Printhead and feed amount cannot be adjusted
when highly transparent lm is loaded.
Adjust the feed amount manually .
( → P .592)
Cannot execute this command. Use other paper .
Cause Corrective Action
The loaded paper cannot be used for color calibration. Load paper compatible with color calibration.*1 See
" Paper Reference Guide ." ( → P .108)
*1: Always make sure the loaded paper matches the media type setting on the printer . Adjustment cannot
be completed correctly unless the setting value matches the loaded paper .
Cannot print as specied.
Press Load/Eject and replace paper with A4/L TR (vertical) or larger
Cause Corrective Action
The loaded paper is too small. Press the Load/Eject button and switch to paper A4/Letter ,
vertical, or larger .
Press Load/Eject and replace roll with 10 in. wide or larger roll.
Cause Corrective Action
The loaded paper is too small. Press the Load/Eject button and load a roll at least 10
inches (254 mm) wide.
Cannot adjust band.
Cause Corrective Action
The Printhead nozzles are clogged. Follow the steps below to check the nozzles.
1. Print a test pattern to check the nozzles.
( → P .623)
2. Clean the Printhead if the nozzles are clogged.
( → P .624)
Highly transparent lm is loaded that cannot be used
for feed amount adjustment.
Adjust the feed amount manually .
( → P .592)
704 Error Message
To Next Page
Loading...
Need help?
General